The perfect solution of safety and possibility of clean and fast work in the spray booth is a spray booth use. However most of the garages cannot afford it.

Prepared the System of Module Spray Stand Extension AUTOKABINA SYSTEM® works on the base of Lego bricks and lets for technical extend of a spray stand from a preparatory sphere to the professional spray booth.

This kind of solution lets for a safe work with a small financial means and instalment of additional modules that will convert a preparatory sphere into a spray booth. This system was worked out for an independent assembly that cause an investment costs decrease.

A - Specially created lower air channel and hoist unit that assures air suck in with a speed of about 0,47 m/sec. through a specially designed floor crates equipped in paint-stop filters. Steering. This kind of equipped working place ensures proper ventilation while any preparatory works. Because of a special shape of crated floor we gain an efficient air stream that is sucked in under a car and efficiently pipe away solvents from the air. Additional elongated channels placed on the sides of working space are to suck in dusts that appear.

B - Inflation ceiling equipped in ceiling filters, lamps, and air circulation systems. Possible curtains (option). Assembling of the inflation ceiling essentially improves working conditions. While the work of the hoist turbine part of the air that was running through the mouth channel now is introduced to the joint assembly. The result of it is a vertical air up and down move. Delivered by this way air is doubly filtered through floor filters and ceiling filters system. This system has a jumping regulation or the air quantity introduced to the closed circulation. Installed lamps improve working conditions. Special curtains can complete the whole. The use of curtains creates an additional working place in the rest part of the repair hall. It lets to keep a proper cleanness in a working place and does not let liquid substances and dusts to go behind the lacquer stand.

C - Air heating module with a heating exchanger and oil burner. Adding this unit causes the possibility of increasing a working pace. Because of an independent heating system that ensures an equal 20^oC temperature while spraying and a drying cycle with a temperature of 60^oC. While installing this element we change an airflow in the zone to make a warm or jot air to be inflated through the joint assembly. By this time we can say that we have a spray booth.

D - Assembling of walls and entering door cause bringing to our device a hypertension parameter. Properly used may bring the result of so called out of dust spray booth work. Mostly is depends on the abilities and habits of the painter. Now our device is not only working but also looks like a spray booth.

E - Extracting ventilator system. This is a challenge for the most ambitious users. Properly built spray booth should always have two ventilation systems: extracting and inflating. 80% of one-system devices (only inflating) in Poland and other Eastern countries are caused with the lack of the money. ONLY so equipped spray booth can be equipped in filters with an active coal.